Shandong Shunhang Generator Rental Co., Ltd.
Address: Jinan City, Shandong Province
Contact: Manager Hao
24h service hotline15066665158
Disposal of oil, water or gas leaks in diesel generator sets @ QingdaoGenerator 13706350233
When the diesel generator set exhibits oil leakage, water leakage, and air leakage, it will cause the diesel generator to increase fuel consumption, accelerate parts wear, reduce power, and other problems. Therefore, it must be repaired in time. The following are the measures to be taken when diesel generators exhibit oil, water and gas leakage:
1. Add pads to prevent leakage
The diesel engine oil pipe joint leak-proof gasket leaks oil, you can add a layer of double-sided lubricating thin plastic pads on both sides of the leak-proof gasket, tighten it tightly to prevent leakage.
2, paint chip liquid leakage
Leakage at the joints of diesel oil tanks, water tanks, crankcases, etc. After soaking the paint film in alcohol, apply the paint film liquid to the cleaned joints to prevent leakage. However, the cost of paint film is high, and it is usually used only when the situation is urgent.
3. Oil leakage control method
When the paper pad of the diesel engine oil pan, cylinder head, gear chamber cover, crankcase back cover, etc. leaks, as long as the paper pad is intact and the joint surface is clean, you can put a layer of butter on both sides of the paper pad and tighten the bolts Leakproof. If you use a new paper pad, soak the new paper pad in diesel for 10 minutes before you install it, then remove it and wipe it off. Put a layer of butter on the joint surface and install it again.
4, liquid sealant leak control method
When the solid gasket defects (such as pits, grooves, and breaks) appear on the diesel engine and constitute interfacial leakage and destructive leakage, apply liquid sealant to the cleaned solid gasket separation surface. After curing, it can constitute an average, Stable, continuously adhered, peelable film gasket prevents all leaks.
5, anaerobic glue leak control method
When the ventilation bolts, stud bolts, plugs, etc. on the diesel engine leak, apply anaerobic adhesive to the cleaned bolts, threads or screw holes, which can quickly cure to form a film, fill the gaps between parts, and can accept Large pressure, and also has a strong anti-vibration and anti-loose fastening function. Such as used in the diesel engine high-pressure oil pipe joint thread, leakage control effect is better.
6. Dimensional recovery glue to cure leakage
When the shaft and shaft sleeve, bearing and bearing seat, valve and valve seat, self-tightening oil seal, felt cup and packing packing on the diesel engine leak, you can use the size recovery glue to apply to the cleaned and worn parts of the mating parts, etc. After curing, it forms a thin film layer that is wear-resistant, heat-resistant, and has high mechanical strength, and then stops turning, boring, scraping, filing, and other mechanical processing to restore the geometric shape and fitting accuracy of the part, so as to deal with leakage problems.
7. Sticky glue to prevent leakage
When the body parts on the diesel engine, such as trachoma and stomata in the fuel tank, water tank, oil pipe, water pipe, etc., cause leakage, apply the adhesive to the clean and damaged areas to receive the effect of leak control.
The above information is shared by Zibo Generator, Qingdao Generator Leasing